Grandstream Networks GXP17 Series Administration Guide

P a g e | 69
GXP21XX Administration Guide
Preferred DNS Server
Enters the Preferred DNS Server for Ipv4.
Ipv6 Address Type
Allows users to configure the appropriate network settings on the phone to
obtain Ipv6 address. Users could select “Auto-configured” or “Statically
configured” for the Ipv6 address type.
Static Ipv6 Address
Enter the static Ipv6 address when Full Static is used in “Statically
configured” Ipv6 address type.
Ipv6 Prefix Length
Enter the Ipv6 prefix length when Full Static is used in “Statically configured”
Ipv6 address type.
Ipv6 Prefix
Enter the Ipv6 Prefix (64 bits) when Prefix Static is used in “Statically
configured” Ipv6 address type.
DNS Server 1
Enter the DNS Server 1 for Ipv6.
DNS Server 2
Enter the DNS Server 2 for Ipv6.
Preferred DNS server
Enter the Preferred DNS Server for Ipv6.
Network  Advanced Settings
802.1X mode
Allows the user to enable/disable 802.1X mode on the phone. The default
value is disabled. To enable 802.1X mode, this field should be set to EAP-
MD5, users may also choose EAP-TLS, or EAP-PEAP.
802.1X Identity
Enter the Identity information for the 802.1x mode.
MD5 Password
Enter the MD5 Password for the 802.1X mode.
802.1X CA Certificate
Upload 802.1X CA certificate to the phone; or delete existed 802.1X CA
certificate from the phone.
802.1X Client
Certificate
Uploads 802.1X Client certificate to the phone; or delete existed 802.1X
Client certificate from the phone.
HTTP Proxy
Specifies the HTTP proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
HTTPS Proxy
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Bypass Proxy For
Enter host names that do not require a proxy to reach. Those names should
be separated by commas.
Layer 3 QoS for SIP
Defines the Layer 3 QoS parameter for SIP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 26.
Layer 3 QoS for RTP
Defines the Layer 3 QoS parameter for RTP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 46.
Enable DHCP VLAN
Enables auto configure for VLAN settings through DHCP. Disabled by
default.
Layer 2 QoS
802.1Q/VLAN Tag
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Layer 2 QoS 802.1p
Priority Value
Assigns the priority value of the Layer2 QoS packets. The default value is 0.

Grandstream Networks GXP17 Series Specifications

General

Brand	Grandstream Networks
Model	GXP17 Series
Category	IP Phone
Language	English