FIRMWARE VERSION 1.0.9.1 GXW40XX USER MANUAL Page 33 of 60
This option specifies the name of the client. This field is optional but may be
required by some Internet Service Providers. Default is blank.
Used by clients and servers to exchange vendor-specific information. Default is
HT500.
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point
Protocol over Ethernet) connection.
This field is optional. If your ISP uses a service name for the PPPoE connection,
enter the service name here. Default is blank.
Controls how the date/time is displayed according to the specified time zone.
The syntax is std offset dst [offset],start[/time],end[/time]
Default is set to : MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
It indicates a time zone with 6 hours offset with 1 hour ahead which is the US
central time.
It is positive (+) if the local time zone is west of the Prime Meridian and negative
(-) if it is east.
Prime Meridian (International or Greenwich Meridian)
M3.2.0,M11.1.0
The 1st number indicates Month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
The 2nd number indicates the nth iteration of the weekday: (1st Sunday, 3rd
Tuesday etc)
The 3rd number indicates Weekday: 0,1, 2, ..,6(for Sun, Mon, Tue, .., Sat)
Therefore, this example is the DST which starts from the second Sunday of
March to the 1st Sunday of November.
Default is English. Languages supported with voice prompt.
This parameter controls whether the device is working in NAT router mode or Bridge
mode. Save the setting and reboot prior to configuring the GXW.
Note: This option is not present on GXW4024
Maximum NAT ports, typically one connection per port.
Note: This option is not present on GXW4024
NAT TCP timeout in seconds
Note: This option is not present on GXW4024
To Next Page
Loading...
Need help?
General
