Grandstream Networks HT701 User Manual

P a g e | 21
HT70X User manual
Version 1.0.9.4
13
Firmware Server IP
Address
Announces current Firmware Server IP address.
Enter 12 digit new IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address.
Enter 12 digit new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration
update. Press “9” to toggle between TFTP / HTTP /
HTTPS
16
Firmware Version
Firmware version information.
17
Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among
the following three options:
• always check
• check when pre/suffix changes
• never upgrade
47
“Direct IP Calling”
Enter the target IP address to make a direct IP call,
after dial tone. (See “Make a Direct IP Call”.)
86
Voice Mail
Access to your voice mails messages.
99
“RESET”
Press “9” to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
“Invalid Entry”
Automatically returns to main menu
“Device not registered”
This prompt will be played immediately after off hook
If the device is not register and the option “Outgoing
Call without Registration” is in NO
Notes:
▪ “*” shifts down to the next menu option and “#” returns to the main menu.
▪ “9” functions as the ENTER key in many cases to confirm or toggle an option.
▪ All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168000026. No decimal is needed).
▪ Key entry cannot be deleted but the phone may prompt error once it is detected.

Grandstream Networks HT701 Specifications

General

Brand	Grandstream Networks
Model	HT701
Category	Adapter
Language	English