Grandstream Networks HT701 User Manual

P a g e | 32
HT70X User manual
Version 1.0.9.4
Configuring the HT70X through Voice Prompts
As mentioned previously, The HT70X has a built-in voice prompt menu for simple device configuration.
Please refer to “Understanding HT70X Interactive Voice Prompt Response Menu” for more information
about IVR and how to access its menu.
• DHCP MODE
Select voice menu option 01 to allow the HT70X to use DHCP.
• STATIC IP MODE
Select voice menu option 01 to allow the HT70X to enable the STATIC IP mode, then use option 02, 03,
04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
• FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
• CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
• UPGRADE PROTOCOL
Select the menu option 15 to choose firmware and configuration upgrade protocol between TFTP, HTTP
and HTTPS.
• FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
“Always check, check when pre/suffix changes, and never upgrade”.
Table 8: Basic Settings
End User Password
Password to access the Web Configuration Menu. This field is case sensitive
with a maximum length of 25 characters.
Web Port
By default, HTTP uses port 80. This field is for customizable web port.
Telnet Server
Default is set to Yes.
HTTP Access
Default is set to Yes. If set to No, http access will be denied.

Grandstream Networks HT701 Specifications

General

Brand	Grandstream Networks
Model	HT701
Category	Adapter
Language	English