• Added the options to restrict outgoing call duration [Outgoing Call Duration Limit]
• Added the options to configure [Ring Frequency]
• Added the options to [Enable High Ring Power], to support device consumer more power from FXS
port.
• Added the options to enable/disable [Generate Continuous RFC2833 Events].
• Added the options to configure [SIP REGISTER Contact Header Uses] it’s WAN or LAN address.
• Added the options to [Disable Multiple m line in SDP].
• Added the options to configure [SIP Timer D].
• Added the options to configure [Country Specific Deployment]
Firmware Version 1.0.6.1
• Added the options to enable/disable [Always send HTTP Basic Authentication Information]
• Rearrange Layer 2 QoS setting options [Layer 2 QoS], and move [Layer 3 QoS] to FXS Port page
Firmware Version 1.0.5.2
• Added the option to define [Voice Frames per TX]
• Added the options to enable/disable [Use P-Preferred-Identity Header] and [Use Privacy Header]
• Added the option to enable/disable [Add Auth Header On Initial REGISTER]
Firmware Version 1.0.4.14
• Added the option to enable/disable [Allow DHCP Option 120(override SIP server)]
• Added the option [DTMF Caller ID Tone] to define DTMF call ID Start/Stop Tone
Firmware Version 1.0.4.8
• Added the option to enable/disable HTTP Access [HTTP Access]
• Added the option to enable/disable Authenticate incoming INVITE [Authenticate incoming INVITE]
• Added ability to configure the time of re-register before registration expired [Reregister before Expiration]
• Updated Table3 Advanced Definitions of the HT70X LEDs Pattern
• Added the option to enable/disable Use DNS to detect network connectivity [Use DNS to detect network
connectivity]
To Next Page
Loading...
Need help?
General
