HT70X User manual
Version 1.0.9.4
The user name needed to authenticate with the HTTP/HTTPS server.
The password needed to authenticate with the HTTP/HTTPS server.
Always send HTTP
Basic
Authentication
Information
Default is Send HTTP Basic Authentication Information only when
challenged. If set to Always, device will send configured user name and
password within HTTP request without server sending authentication challenge.
Default is blank. If configured, HT701 will request firmware file with the prefix.
This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Allow DHCP Option
66 or 160 to
override server
If set to “Yes”, configuration and upgrade server information can be obtained using
DHCP option 66 or option 160 from DHCP server located in customer’s
environment. Default setting is Yes.
Enables automatic provision feature on the phone when 3CX is used as the SIP
server. The default setting is "Yes".
Choose “Yes” to enable automatic upgrade and provisioning. If select “Check
every minutes” input the amount of minutes you want it to check for update. If
select “Yes, daily at hour” make sure to input the hour of the day you want it to
check for update, e.g. for 11 pm type 23. If select “Yes, weekly on day” make sure
you input the day of the week (in format 0-6, 0 is Sunday) you want it to check for
update. When set to No, HT70X will only do the following option you select;
“Always check for New Firmware at Boot up” will check for new firmware every
time the device reboots. “Check New Firmware only when F/W pre/suffix changes”
will check for updates only when the pre/suffix has been changed.
To Next Page
Loading...
Need help?
General
