Grandstream Networks HT701 User Manual

P a g e | 46
HT70X User manual
Version 1.0.9.4
Hold Target Before
Refer
Default is Yes. Allows user to hold the phone call before refer it. If set to No, the
call will not be hold before referred.
Refer to Use Target
Contact
Default is No. If set to YES, then for Attended Transfer, the “Refer-To” header
uses the transferred target’s Contact header information.
Transfer on
Conference Hang up
Default is No. In which case if the conference originator hangs up the
conference will be terminated. When option YES is chosen, originator will
transfer other parties to each other so that B and C can choose to either continue
the conversation or hang up.
Enable Ring-Transfer
Default is No, this will create a Semi-Attendant Transfer. When set to Yes,
device can transfer the call upon receiving ring back tone or SIP message 180.
Disable Bellcore
Style 3-Way
Conference
Default is No. you can make a Conference by pressing ‘Flash’ key. If set to Yes,
you need to dial *23 + second callee number.
Remove OBP from
Route Header
Default is No. When option YES is chosen, the Out Bound Proxy will be removed
from Route header.
Support SIP Instance
ID
Default is Yes. If set to Yes, the contact header in REGISTER request will
contain SIP
Instance ID as defined in IETF SIP Outbound draft.
Validate incoming
SIP message
Default is No. If set to yes all incoming SIP messages will be strictly validated
according to RFC rules. If message will not pass validation process, call will be
rejected.
Check SIP User ID
for incoming INVITE
Default is No.
Check the incoming SIP User ID in Request URI. If they don’t match, the call
will be rejected. If this option is enabled, the device will not be able to make
direct IP calls.
Authenticate
incoming INVITE
Default is No. If set to Yes, device will challenge the incoming INVITE for the
Authenticate ID and Password with 401 Unauthorized.
Authenticate server
certificate domain
Default is No.
If set to Yes, device will authenticate server certificate domain.
Authenticate server
certificate chain
Default is No.
If set to Yes, device will authenticate server certificate chain.
Trusted CA
certificates
Default is null. Or you can configure your trusted CA certificates manual after
enabled Authenticate server certificate domain.

Grandstream Networks HT701 Specifications

General

Brand	Grandstream Networks
Model	HT701
Category	Adapter
Language	English