HT70X User manual
Version 1.0.9.4
Set the IP or FQDN of the Primary RADIUS Server. HT704 Only
Remote Authentication Dial In User Service (RADIUS). HT704 supports RADIUS
for authentication, authorization and billing purposes. Primary and secondary
RADIUS server configurations are available to provide redundancy to this feature.
In case Primary Radius server becomes unusable, RADIUS requests will be
automatically sent to the secondary server. When at least one RADUIS server was
configured, the device will allow users to make phone calls only after authorization
from RADIUS server has been received. CDR (Call Detail Record) is also sent to
the RADIUS server for billing purposes. RAIDUS server can send requests to
terminate calls when run out of pre-paid credit.
Default is 1812. Specifies the port to be used for the Primary RADIUS
Authentication. HT704 Only
Default is 1813. Specifies the port to be used for the Primary RADIUS Account.
HT704 Only
Primary RADIUS
Server Secret
Specifies the secret string to be used to authenticate the RADIUS connection to
the Primary Server. It should match RADIUS configuration. HT704 Only
Set the IP or FQDN of the Secondary RADIUS Server. HT704 Only
In case Primary Radius server becomes unusable, secondary will take role of
primary and will manage credit recourses in the network
Secondary RADIUS
Auth Port
Default is 1812. Specifies the port to be used for the Secondary RADIUS
Authentication. HT704 Only
Secondary RADIUS
Acct Port
Default is 1813. Specifies the port to be used for the Secondary RADIUS
Account. HT704 Only
Secondary RADIUS
Server Secret
Specifies the secret string to be used to authenticate the RADIUS connection to
the Secondary Server. It should match RADIUS configuration HT704 Only
To Next Page
Loading...
Need help?
General
