Grandstream Networks HT701 User Manual

P a g e | 49
HT70X User manual
Version 1.0.9.4
Disable Call Waiting
Tone
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting
information arrives. The CWCID information will still be displayed.
Disable Connected
Line ID
Default is No. If set to Yes will disable the connect line ID appear on device.
Disable Receiver
Offhook Tone
Default is No. If set to Yes, it will disable the warning to alert that the phone has
been left off-hook for an extended period of time.
Disable Reminder
Ring for On-Hold Call
Default is No. Do not play the reminder ring when this is set to Yes.
Disable Visual MWI
Default is No. If set to “Yes”, the MWI information will not be transferred to the
analog phone connected to the FXS port.
Ring Timeout
Default value is 60 Sec. Incoming call will stop ringing when not picked up given
a specific period of time.
Hunting Group Ring
Timeout
Default value is 20 Sec. If call is not answered within this designated time period,
the call will be forwarded to the next member of a Hunt Group. HT704 only.
Hunting Group Type
Linear and Circular. Default is Circular. Linear style will sort the call to the
lowest-numbered available line, this is also called “serial hunting”. Circular style
will distribute the calls "round-robin". If a call is assigned to line 1, the next call
goes to 2 and the next to 3.
The succession throughout each of the lines continues even if one of the
previous lines becomes available. When the end of the hunt group is reached,
the hunting starts over at the firstline. Lines are skipped if they are still busy on
a previous call. HT704 only
Delayed Call Forward
Wait Time
Default value is 20 seconds. In case this feature activated using * codes (*92
code), the call will be forwarded after this preconfigured amount of time.
No Key Entry
Timeout
Default is 4 seconds. Dialing process is completed and outgoing call is initiated
if no key entry occurs during this preconfigured interval.
Early Dial
Default is No. Use only if proxy supports 484 response. This parameter
controls whether the phone will send an early INVITE each time a key is pressed
when a user dials a number. If set to “Yes”, an INVITE is sent using the dial-
number collected thus far; Otherwise, no INVITE is sent until the “(Re-)Dial”
button is pressed or after about 5 seconds have elapsed if the user forgets to
press the “Re-Dial” button.
The “Yes” option should be used ONLY if there is a SIP proxy configured and
the proxy server supports 484 Incomplete Address response.

Grandstream Networks HT701 Specifications

General

Brand	Grandstream Networks
Model	HT701
Category	Adapter
Language	English