IMPORTANT NOTE FOR INSTALLERS
These instructions are intended to guide installers on the installation,
commissioning and servicing of the Grant Aerona³ heat pump. After
installing the heat pump, leave these instructions with the user.
A user handbook is available to guide users in the operation of the heat
pump.
SPECIAL TEXT FORMATS
The following special text formats are used in these instructions for the
purposes listed below:
PRODUCT CODES COVERED
These instructions cover the following product codes:
Product code
HPID6R32 - 6kW
HPID10R32 - 10kW
HPID13R32- 13kW
HPID17R32- 17kW
Output at 7°C air and 35°C flow temperature
SERVICING
The heat pump should be serviced at least every twelve months and the
details entered in the Service Log in the user handbook.
WARNING
Warning of possible human injury as a
consequence of not following the instructions
in the warning.
Caution concerning likely damage to
equipment or tools as a consequence of not
following the instructions in the caution.
Used for emphasis or information not directly
concerned with the surrounding text but of
importance to the reader.
CAUTION
NOTE
IMPORTANT NOTE FOR
INSTALLERS
The data label gives you very important
information about the installed heat pump.
Do not remove this label from the heat
pump under any circumstances. The year of
manufacture is contained within the serial
number (SN). The last two digits of the
middle
set of four numbers (eg. 8820) indicates the
year of manufacture.
In this example, the year is 2020
Power Quality Information
HPID6R32 Complies with the Technical requirements of BS EN/IEC 61000-3-2
Complies with the Technical requirements of BS EN/IEC 61000-3-3
HPID10R32 Complies with BS EN/IEC 61000-3-11 & BS EN/IEC 61000-3-12
Complies with the technical requirements of BS EN/IEC 61000-3-2
Complies with the technical requirements of BS EN/IEC 61000-3-3
HPID13R32 Complies with BS EN/IEC 61000-3-11 & BS EN/IEC 61000-3-12
HPID17R32 Complies with BS EN/IEC 61000-3-11 & BS EN/IEC 61000-3-12
8820
This manual is accurate at the date of printing but will be superseded and should be disregarded if specifications and/or appearances are changed in the interests of continued product improvement. However, no respon-
sibility of any kind for any injury, death, loss, damage or delay however caused resulting from the use of this manual can be accepted by Grant Engineering (Ireland) ULC, the author or others involved in its publication.
All good sold are subject to our official Conditions of Sale, a copy of which may be obtained on application.
© Grant Engineering (Ireland) ULC No part of this manual may be reproduced by any means without prior written consent.
GRANT ENGINEERING (IRELAND) ULC
Crinkle, Birr, Co Offaly
R42 D788, Ireland
www.grantengineering.ie
Email: info@grantengineering.ie
Tel:+353 (0)57 91 20089 Fax: +353 (0)57 91 21060
To Next Page
Loading...
Need help?
General
