Section 16: Product Fiche - HPID13R32Page 76
Product fiche concerning the Commission Delegated Regulations
(EU)No 811/2013 of 18 February 2013
(EU)No 813/2013 of 2 August 2013
Contact Details:
Grant Engineering (Ireland) ULC, Barrack Street, Crinkle, Birr, Co. Offaly, R42
D788, Ireland.
(*) For heat pumps space heaters and heat pump combination heaters, the rated heat output Prated is equal to the design load for heating Pdesignh, and
the rated heat output of a supplementary heater Psup is equal to the supplementary capacity for heating sup(Tj).
(**) If Cdh is not determined by measurement then the default degradation coefficient is Cdh = 0.9.
Low Temperature Heat Pump
Equipped with Supplementary Heater
Heat Pump Combination Heater
Parameters shall be declared for
Medium Temperature Applications (55°C)
Parameters shall be declared for
Average Climate Conditions
Item
Symbol
Value
Unit
Item
Symbol
Value
Unit
Rated Heat Output (*)
Prated
10.0
kW
Seasonal space heating
energy efficiency
ƞs
149
%
Declared capacity for heating for part load at indoor Declared coefficient of performance or primary energy ratio for
Temperature 20°C and outdoor temperature Tj part load at indoor temperature 20°C and outdoor temperature Tj
Degradation co-efficient (**)
Degradation co-efficient (**)
Degradation co-efficient (**)
Degradation co-efficient (**)
Degradation co-efficient (**)
Tj = bivalent temperature
Tj = bivalent temperature
Tj = operation limit
temperature
Pdh 10.0 kW Tj = operation limit temperature COPd
2.05
Tj = -15°C (if TOL < -20°C)
Tj = -15°C (if TOL < -20°C)
Operation limit temperature
Heating water operating limit
temperature
WTOL
60 °C
Power consumption in modes other than active mode
OFF
sup
TO
SB
CK
Capacity control Variable
Rated airflow rate, outdoors - 4464 m³/h
Sound power level
indoors/outdoors
WA
39/61
Annual Energy consumption
HE
For heat pump combination heater
Water heating energy efficiency
Reference Hot Water Temperature
WH
Daily electricity consumption
Actual Volume of cylinder under test
Annual electricity consumption
Standby Cylinder Heat Loss