Section 16: Product Fiche - HPID10R32 Page 75
Contact Details:
Grant Engineering (Ireland) ULC, Barrack Street, Crinkle, Birr, Co. Offaly, R42 D788, Ireland.
(*) For heat pumps space heaters and heat pump combination heaters, the rated heat output Prated is equal to the design load for heating Pdesignh, and
the rated heat output of a supplementary heater Psup is equal to the supplementary capacity for heating sup(Tj).
(**) If Cdh is not determined by measurement then the default degradation coefficient is Cdh = 0.9.
Low Temperature Heat Pump
Equipped with Supplementary Heater
Heat Pump Combination Heater
Parameters shall be declared for
Low Temperature Applications (35°C)
Parameters shall be declared for
Average Climate Conditions
Seasonal space heating
energy efficiency
Declared capacity for heating for part load at indoor Declared coefficient of performance or primary energy ratio for
Temperature 20°C and outdoor temperature Tj part load at indoor temperature 20°C and outdoor temperature Tj
Degradation co-efficient (**)
Degradation co-efficient (**)
Degradation co-efficient (**)
Degradation co-efficient (**)
Tj = bivalent temperature
Tj = bivalent temperature
Tj = operation limit
temperature
Tj = operation limit temperature
Tj = -15°C (if TOL < -20°C)
Tj = -15°C (if TOL < -20°C)
Operation limit temperature
Heating water operating limit
temperature
Power consumption in modes other than active mode
Rated airflow rate, outdoors
Sound power level
indoors/outdoors
Annual Energy consumption
For heat pump combination heater
Water heating energy efficiency
Daily electricity consumption
Annual electricity consumption
Product fiche concerning the Commission Delegated Regulations
(EU)No 811/2013 of 18 February 2013
(EU)No 813/2013 of 2 August 2013