FC8600-UM-251-9370 V
7.3.13 Adjusting the Spacing Between Pen 1 and Pen 2 (2-pen model) .....................................................7-36
7.3.14 Adjusting the Tool 2 and the Cross Cutter Threshold (2-pen model) ............................................. 7- 40
7.4 Upgrading the System Firmware ....................................................................................... 7- 42
8 TROUBLESHOOTING ............................................................... 8-1
8.1 The Plotter is Turned On But Doesn’t Operate ................................................................... 8-1
8.2 Media Loading Operations ................................................................................................... 8-1
8.3 Cutting Operations ............................................................................................................... 8-2
8.4 Error Messages ..................................................................................................................... 8-3
8.4.1 Hardware Error Messages .................................................................................................................... 8-3
8.4.2 Error Messages in GP-GL Command Mode ........................................................................................ 8-6
8.4.3 Error Messages in HP-GL Emulation Mode ........................................................................................ 8-7
8.4.4 Error Messages on ARMS ..................................................................................................................... 8-9
8.4.5 Other Error Messages ..........................................................................................................................8-12
8.4.6 Warning Messages ...............................................................................................................................8-13
8.5 Service mode........................................................................................................................8-14
8.5.1 Sensor Test Mode & Panel Switch Test Mode ....................................................................................8-14
8.5.2 Printing the Setting of the Plotter ..........................................................................................................16
8.5.3 Printing the Test Pattern .........................................................................................................................17
8.5.4 Confirm the Cutting Data ........................................................................................................................18
8.5.5 Self Diagnostic Test ................................................................................................................................. 19
9 PARTS LIST ............................................................................... 9-1
9.1 Outer Casing.......................................................................................................................... 9-1
9.2 Control Panel ......................................................................................................................... 9-3
9.3 Pen Block ............................................................................................................................... 9-4
9.4 Registration Mark Sensor Assy ........................................................................................... 9-6
9.5 Cross Cutter .......................................................................................................................... 9-7
9.6 Main Frame ............................................................................................................................ 9-8
9.7 Y Rail .....................................................................................................................................9-10
9.8 Y Slider ..................................................................................................................................9-12
9.9 Wiring Harness .....................................................................................................................9-13
9.10 Labels ....................................................................................................................................9-14
To Next Page
Loading...
