3-16
Settings and Measurement
The maximum data capture time that can be selected depends on the
sampling interval.
• 24 hours: 1s or less sampling interval
• 12 hours: 500 ms or less sampling interval
• 6 hours: 200 ms or less sampling interval
• 3 hours: 100 ms or less sampling interval
If the allowable data capture time is exceeded, the actual data capture
time will be shortened.
Replay Settings
Selects the data replay source for replaying captured data.
Replay Source .................... Selects the source for loading data for replay as Internal Memory or
PC card.
Memory: Replays data captured to the internal memory.
The sampling interval and the number of captured data are displayed.
PC card: Replays data captured to a PC card. Select the relevant file.
Statistical Calculation.......... Statistical calculation is performed on the replay data between the
cursors.
Function: There are five types of between-cursor calculation
functions, and four of these can be selected.
Off: Calculation is not performed.
Average: The simple average value of the data between the cursors is
displayed.
Max: The maximum value of the data between the cursors is
displayed.
Min: The minimum value of the data between the cursors is
displayed.
Peak: The peak value of the data between the cursors is displayed.
RMS: The effective value of the data between the cursors is
displayed.
R.M.S = ΣD
2
/n
D: data n: number of data
Channel specification: Specifies the two channels "A" and "B" for
calculation.
To Next Page
Loading...