3-22
Settings and Measurement
yy
yy
y I/F Settings Window
The conditions for connecting to your computer are set here.
New Line Code ................... Sets the new line code. Select from CR+LF, LF, or CR.
Echo Back........................... This function can be specified as Enable or Disable.
USB ID Setting.................... Sets the ID number for the GL400. Specify a number from 0 to 7.
TCP-IP Settings .................. Sets the TCP-IP.
IP Address: Sets the IP address.
Subnet Mask: Sets the subnet mask.
Port Number: Sets the port number.
CHECKPOINT
Be sure to restart the GL400 after settings have been made or changed. If the GL400 is used as is, the
computer connections may not be performed correctly.
Setting Selections available Setting method
New Line Code CR+LF, LF, CR ENTER→Select→ENTER
Echo Back Enable, Disable ENTER→Select→ENTER
USB ID 0 to 7 ENTER→Select→ENTER
IP Address Numeric setting ENTER→Select→ENTER
Subnet Mask Numeric setting ENTER→Select→ENTER
Port Number Numeric setting ENTER→Select→ENTER
To Next Page
Loading...