Settings and Measurement
3-27
Search ................................ This function searches for the alarm setting position within the
captured data.
Alarm Output No.: Specify a number that has been set for the alarm
settings (1 to 4).
Alarm Slope: Specify the generation condition for the alarm search.
• Both: Both rising and falling
• Hi: Rising only
• Lo: Falling only
Next Alarm Match/Prev. Alarm Match:
Depending on whether Next or Prev. has been selected, matching
data from the current cursor position to the next alarm position, or
from the previous alarm position to the current cursor position is
searched for and displayed.
Statistical Calculation.......... Statistical calculation is performed on the replay data between the
cursors.
Function: There are five types of between-cursor calculation
functions, and four of these can be selected.
• Off: Calculation is not performed.
• Average: The simple average value of the data between the cursors
is displayed.
Setting Selections available Setting method
Search
• Alarm Output No. 1 to 4 ENTER→Select→ENTER
Alarm Slope Both, Hi, Lo ENTER→Select→ENTER
Next Alarm Match ENTER
Prev. Alarm Match ENTER
Statistical Calculation
• Function Off, Average, Max, Min, Peak, RMS ENTER→Select→ENTER
Specify calculation channels
Select channels from the input terminal unit: 2 ch
ENTER→Select→ENTER
Save to Card Specify data save destination (PC card only)
(Between Cursors) • File Type: GBD, CSV ENTER→Select→ENTER
• Name Type: Auto, User ENTER→Select→ENTER
• File: Folder name, file name ENTER→Specify file→OK
• Confirm ENTER
Move cursor Move to selected position
•
Move to Selected Position
• Selected method: Position, Time ENTER→Select→ENTER
• Position Moved To (Position only) Between
ENTER→Specify numeric value
Upper and Lower Limit Values
→ENTER
(Time only) Specified time
ENTER→Specify numeric value
→ENTER
• Execute ENTER
Move to First Data ENTER
Move to Last Data ENTER
To Next Page
Loading...