3−5
CHAPTER 3 Settings and Measurement
14. File name display
(1) During data capture
A capture file name is displayed during capture.
* If the ring capture setting is ON, a file name displayed during capture ends with "_RINGx" (x represents
a number) but the actual file name does not include "_RINGx".
In the above figure, if the ring capture is set to ON, the file name during capture will be displayed, for
example, as "<MEM>091225\091225-130620_UG_RING4.GBD" but the actually created file will be
"<MEM>091225\091225-130620_UG.GBD".
* Refer to page 3-26 for details on the ring capture setting.
(2) During data replay
Information on the time axis of the cursor is displayed during replay.
Time difference between Cursors A and B
Selected cursor
Time to which the cursor points
15. Lower limit scale
Displays the lower limit scale of the currently active channel.
16. Waveform display
Displays the waveform of the input signal.
17. Upper limit scale
Displays the upper limit scale of the currently active channel.
18. Data capture bar
(1) During data capture
Displays the elapsed time and the memory usage status.
Remaining time for data capture
Amount of memory used Amount of memory remaining
Total amount of memory
Elapsed time
If, for example, 256 MB USB memory is inserted and about 96 MB is used before data capture, the total
amount of memory is 256 MB, the amount of memory used is about 96 MB, and the amount of memory
remaining is about 160 MB. As time elapses during data capture, the amount of used memory increases
and the amount of remaining memory decreases.
The remaining time for data capture shows a length of time during which data capture is available with the
amount of remaining memory. If the amount of remaining memory is more than 2 GB, however, this part
shows remaining time during which data capture is available with one 2 GB file.
* Remaining time more than 99999 hours is displayed as "++++
:++:++".
(2) During data replay
Displays the display position, cursor position, and trigger position graphically.
Range for which a waveform
is currently displayed
Capture data size
Cursor A position Cursor B position
To Next Page
Loading...
