3−7
CHAPTER 3 Settings and Measurement
(2) SPAN/TRACE/POSION
Switches the display in the digital display.
Used to change the settings related to waveform display during Free Running (when stopped),
data capture and data replay.
Pressing this key will switch displays as shown below.
MONITOR SPAN POSITION TRACE
Displays digital values
(default status)
Allows changing of the span value
(waveform amplitude)
▪ Channel change : keys
▪ Amplitude change : keys
▪ Change available : Voltage 8 steps
/Temperature 6 steps
Allows changing of the position
(waveform up/down position)
▪ Range can be changed in units of 10%
▪ Channel change : keys
▪ Position change : keys
▪ Change available : 10% steps of range
Allows turning ON/OFF of the
waveform display
▪ Channel change : keys
▪ Position change : keys
▪ Change available : ON/OFF
* Data is captured even if OFF is set.
* When ALL is set, setting values for CH1 is reflected on other channels.
When CH1 is OFF, ALL Cannot be set.
(3) TIME/DIV
Press the left/right key of the TIME/DIV key to change the time axis display width.
(4) MENU
Open the settings window to capture data. For details on settings, see “3.4 Setting
Menus” on page 3-17.
To Next Page
Loading...
