GRAPHTEC GL820 - Page 59

3−23
CHAPTER 3 Settings and Measurement
(1)-11 EU (Scaling settings)
Converts the measured signals to other units.
This setting is available only if Pulse is selected in (1)-7.
Setting Description
(1) EU Function Sets the scaling function to ON or OFF.
(2) Meas. Value Sets a value to be converted.
(3) EU Output Value Sets an output value after conversion.
(4) Select
Selects a specific engineering unit classification.(The fol-
lowing are available.)
Current, length, area, volume, speed, acceleration, fre-
quency,weight,work,pressure,owrate,temperature
(5) Choose
Selects a unit to be used after conversion.
A unit displayed in this field belongs to the classification
selected in "Select."To set a unit not displayed in this field,
set arbitrary text in "Arbitrary unit." The setting selected in
this field is displayed in "Arbitrary unit."
(6) Arbitrary Unit
Sets a unit to be used after conversion.
Arbitrary text consisting of alphabetical characters and
numerical values can be set as a unit. (Refer to page 3-46
for details on the text input.)When "Select" or "Choose" is
used, the setting is reflected in this field.
 • Ifamessagewindowopens,followtheinstructioninthemessagetochangethesettingvalue.
 • TheScalingfunctionperformscalculationusingaratiooftheMeas.ValueandEUOutputValue
settings.
The digital display shows “++++/----” when the converted value cannot be processed by the GL820.
㪉㪇㪇㪇
8001000
rpm
1000
0
800
CH.1 Scaling 1
0
Meas. Value EU Output Value Dec pt Choose
+
xx.xx
Setting example
(1)-12 Misc.
<For Logic> <For Pulse>
Setting Description
(1) Waveform Color
Setting
0 to 31 for each of red, green, blue (RGB)
(2) Amplitude Setting
1 to 8 dots