GRAPHTEC GL820 - Page 71

3−35
CHAPTER 3 Settings and Measurement
(5) Interface settings
This menu is used to specify conditions for PC connection.
Setting Selections available
Selections availableNew Line code CR+LF, LF, CR
USB
settings
USB ID
0 to 9
TCP-IP
setting
AutoIPAddressAcquisition
On, Off
IP Address
0-255.0-255.0-255.0-255(onlyifAutoIPAddressAcquisi-
tion is Off)
Subnet Mask
0-255.0-255.0-255.0-255(onlyifAutoIPAddressAcquisi-
tion is Off)
Port Number
1024~65535
Gateway
0-255.0-255.0-255.0-255(onlyifAutoIPAddressAcquisi-
tion is Off)
DNS Address
0-255.0-255.0-255.0-255(onlyifAutoIPAddressAcquisi-
tion is Off)
Keep Alive
Off; 10, 30 seconds; 1, 10, 30 minutes; 1 hour
FTP server
settings
FTP Server
Text input
User Name
Text input
Password
Text input
Port Number
0~65535
PASV Mode
Off, On
FTP Server Connec-
tion Test
Press right key to execute.
Host Name Text input
Reflect Settings
Press right key to execute.
(5)-1 New Line code
Specifies the line feed code.
Selection item Description
CR+LF Starts a new line with CR+LF code (default value).
LF Starts a new line with LF code.
CR Starts a new line with CR code.
(5)-2 USB settings
Sets the USB ID number of GL820.
Specify a number from 0 to 9 (default value: 0).
TocontrolmorethanoneGL820unitwithonePC,assignauniqueUSBIDtoeachofthem.