GRAUPNER mx-20 Hott

156
Detail program description - Control adjust
FL
0%
0%
fl.pos
EL FL 0%0%
0%
AILE
Normal
Diff.
0%
Ail-tr
AI
+100%
+100%
… are shown, and – one "step" to the right – all options
for the second aileron pair …
0%
0%
0%0%
0%
AILE2
0%
+100%
+100%
FL
fl.pos
EL FL
Normal
Diff.
Ail-tr
AI
… are shown, and – one further "step" to the right – all
options for the fl ap pair as well:
0%
+100%
0%0%
+100%
FLAP
0%
0%
0%
FL
fl.pos
EL FL
Normal
Diff.
Ail-tr
AI
Model type: "4AIL 4FL"
If you connect the servos to the receiver as described
on page 57 and select them appropriately on the "Model
type" menu (see page 82), then the abbreviations "AI",
"AI2", "FL" and "FL2" refer to the following fl aps:
AI
left
AI2
left
FL
left
FL2
left
FL2
right
FL
right
AI2
right
AI
right
Since selecting "4AIL 4FL" means choosing the
maximum number of control surface servos, the
columns "AILE" …
FL
0%
0%
fl.pos
EL FL 0%0%
0%
AILE
Normal
Diff.
0%
Ail-tr
AI
+100%
+100%
… and "AILE2" …
0%
0%
0%0%
0%
AILE2
0%
+100%
+100%
FL
fl.pos
EL FL
Normal
Diff.
Ail-tr
AI
… are supplemented by the columns "FLAP" …
0%
+100%
0%0%
+100%
FLAP
0%
0%
0%
FL
fl.pos
EL FL
Normal
Diff.
Ail-tr
AI
… and "FLAP2":
0%
+100%
0%0%
+100%
FLAP2
0%
0%
0%
FL
fl.pos
EL FL
Normal
Diff.
Ail-tr
AI
Delta/fl ying wing type models with more than two
wing fl aps
If you have selected the "Delta/fl " tail type and selected
the number of wing fl aps in the "Aile/fl aps" line on the
"Model type" menu (following the instructions given
in that section), then the two ailerons will normally not
move when you move the elevator joystick – and the
same will be true for the inner fl aps (FL) and FL2 (if
present). The reason for this is the default mixer ratio of
0% for all wing fl aps, set for the "EL  FL" mixer that is
to be found on the multi-fl ap menu: