235
Detail program description - Control adjust
Time
1.234
0MB
ABCDEF12
2011/08/01(Mo )
11:22:33s
RFID
firmware ver.
date
time
SD-Card
If necessary, select this line with the arrow keys of the
left or right touch pad and the minute fi eld, if applicable.
After activation of the respective value fi eld by pressing
the central SET key of the right touch pad, the hour or
minute can be adjusted with the arrow keys of the right
touch pad. Pressing the central SET key of the right
touch pad again completes the respective entry.
Contrary to this, the seconds display cannot be directly
adjusted; it can only be restarted by briefl y pressing the
central SET key of the right touch pad with "00".
Notice:
If the transmitter is connected to a PC as described •
on page 39, the date and time can also be set
through the PC program provided for the respective
product on the internet page at www.graupner.de.
The date and time are protected against data loss •
due to power failure by a buffer battery for situations
like a battery change, see page 15.
SD card
1.234
2048MB
ABCDEF12
2011/08/01(Mo )
11:22:33s
RFID
firmware ver.
date
time
SD-Card
In this line the memory capacity of a memory card
inserted in the transmitter, if applicable, is shown in MB.
Depending on the memory capacity of the inserted
micro SD or micro SDHC memory card, it may take
several minutes until the correct value is shown after
switching on the transmitter.
available
1.234
2048MB
2011/02/01(Mo )
11:22:33s
1234MB
firmware ver.
date
time
SD-Card
available
Display of the available storage space in MB.
As mentioned before, the display of the available
storage space – depending on the capacity of the
inserted memory card – does not appear until some time
has passed after switching on the display.
The display of the available storage space in relation to
the total memory capacity is shown in the line below:
2048MB
2011/08/01(Mo )
11:22:33s
1234MB
60%
date
time
SD-Card
available
As mentioned before, the display of the available storage
space – depending on the capacity of the inserted
memory card – does not appear until some time has
passed after switching on the display.
To Next Page
Loading...
