62
Detail program description - Loading a new memory location
CTRL 6 – . This condition changes for both model types
only after the respective assignments have been made
in the "Control adjust" menu.
On the other hand, if a newly initialized model memory
is to be put into operation then it MUST fi rst be
appropriately "connected" with one or more receivers
before the servos attached to the receiver/s can be
operated. More about this can be found in the section
"Binding" on page 69 or 75.
A fundamental description of programming steps for a
winged aircraft model can be found in the programming
examples section beginning on 226, or for helicopter
models beginning on page 270.
The menu descriptions below are arranged in the
sequence individual menus are listed in the multi-
function list.
To Next Page
Loading...
