7
Safety notices
transmitter and receiver.
Prior to every fl ight, perform a complete functional •
test, range test and execute a complete simulated
fl ight in order to exclude the possibility of system
faults or problems with the model's programming.
Never program the transmitter or receiver while the •
model is being operated.
Care and maintenance
Never clean the housing, antenna, etc. with cleaning
agents, gasoline, water or similar means. Use only a dry,
soft cloth.
Components and accessories
As manufacturer of this equipment Graupner GmbH
& Co. KG recommends only components and
accessories which have been tested and approved by
Graupner for their suitability, functionality and safety.
If this recommendation is followed, Graupner accepts
responsibility for the product.
Graupner cannot accept any responsibility for the
parts or accessories of other manufacturers which
have not been approved and Graupner cannot
evaluate every individual product made by other
companies to assess if they are safe to use.
Liability exclusion / damage compensation
This manual serves only as a source of information and
can be changed without prior notifi cation. Graupner
accepts no responsibility or liability for errors or
inaccuracies which may be contained in this manual.
Graupner cannot monitor compliance with the assembly
instructions, the operating instructions or the conditions
and methods under which remote control components
are installed, operated, utilized or maintained. Therefore
Graupner accepts no form of liability for loss, damage or
costs consequential to incorrect usage or operation or
which can be attributed to same.
Unless otherwise prescribed by law, the obligation of
Graupner to provide damage compensation, regardless
of legal grounds, is limited to the invoice value of the
quantity of Graupner. goods contributing directly to the
damage-inducing event. This does not apply if Graupner
is found to be subject to unlimited liability pursuant to
binding legal stipulations with respect to intent or gross
negligence.