Gravely Atlas JSV EFI 2016 - Propshaft U-Joint Disassembly; Propshaft U-Joint Service

7
21901443 R02 - 2016 Gravely Atlas JSV3000 / JSV6000 EFI Service Manual
© Copyright Ariens Company
7.9
PROPSHAFT U-JOINT SERVICE
PROPSHAFT U-JOINT DISASSEMBLY
NOTE
Before servicing the prop shaft U-joint, be sure the joint
is clean to ensure no debris damages the yoke.
1. With the prop shaft removed and marked for
alignment orientation, remove the retaining rings (1)
from both sides of the yoke.
2. Using a commercially available Ball Joint / U-Joint
Press Set, place a receiving cup adapter (2) with a
larger ID than the U-joint cap OD on one end.
3. Place a remover adapter (3) on other end of U-joint
with a smaller OD than the U-joint cap.
4. Position clamp (4) over receiving cup adapter and
remover adapter.
5. Tighten clamp with hand tools to force U-joint cups
out of yoke.
FINAL DRIVE