GRAVOGRAPH IS900 - Information about Regulations and Safety; Electrical Safety

First Contact IS900 IQ
+
Machine - Electronic Engraving machine . 5
Information about regulations
Conformity standards
This hardware was designed and build in conformity with the relevant EC marking and EEC directives :
• "Machine Security" Directive 98/37/EEC (22/06/98).
• "Electromagnetic compatibility" Directive 2004/108/EC
• "Low Voltage" Directive 2006/95/EC
 Themodicationortransformationofthisequipment,theadaptationandinstallationof
accessoriesnotrecommendedbyGRAVOTECHMARKINGSAS,theinstallationofthisequi-
pmentinamanufacturingprocess,thepilotingbyarobot,theconnectiontoanexternal
automaton,modifythecharacteristicsofthismaterialandcanmakeitnotcompliantwith
theEuropeanDirectivesitissubjected.Thesemodicationsvoidstheresponsibilityofthe
manufacturer.
Inthiscase,thepersonwhotsthemachineandtheequipmentisresponsiblefortheEC
complianceofthenalworkstation.
Electricalsecurity
This hardware complies with standards EN 60204-1 and EN 60950-1, which also refer to the LASER system safety stan-
dard CEI 825-1 (08/2001).
The different fuses of the machine comply with the IEC 127-2 norm (International Electric Committee).
The different security levels the input/output answer are indicated for each connector in the chapter «Rear view of the
machine». Two security levels are possible :
- Dangerous voltage (power supply, accessories, plugs ...).
- Very low security voltage.
Machinesecurity
This hardware is in conformity with the norm EN ISO12100-1 and EN ISO12100-2.
Electromagneticcompatibility
This hardware is in conformity with electromagnetic compatibility norms:
• EN 55022 - classe B ; EN 61000-3-2 ; EN 61000-3-3 (emission in residential, commercial, and light industrial
environment)
• EN 61000-6-2 (immunity in industrial environment)
All the cables used with this hardware must be in conformity with the electronic compatibility standards, norm EN 55022
- class B.
AElectricalsecurity
 Thismaterialis«class1».ThemainsplugMUSTalwaysbeconnectedtoaneutralsocket
andcomplywiththeregulationsinforceinthecountryofinstallation.Ifyoudonothave
aplugofthistype,haveoneinstalledbyanapprovedelectrician.Undernocircumstances
shouldyoudepartfromthisinstruction.
The manufacturer bears no responsibility towards any user where alterations have been carried out contrary to the ma-
nufacturer’s specications, notably with respect to electrical/electronic elements.
 Anyoperation,otherthanthosementionedhere,mustonlybecarriedoutbyanapproved
Gravographtechnician.
Donottakethemachineaparttorepairorcleanit:thiswillvoidyourguarantee.
 Thissymbolindicatesthatoncethisequipmenthasreachedtheendofitsusefullife,it
mustnotbedisposedofwithnon-sortedmunicipalwaste,inaccordancewiththeEuropean
Directive2002/96/EC.
The equipment must be disposed of at an appropriate collection point for processing,
sorting,andrecyclingofWasteElectricalandElectronicEquipment(DEEE).
The elements which compose Electrical and Electronic Equipment may contain
substanceswhichhaveharmfuleffectsontheenvironmentoronhumanhealth.
By following these instructions, you are helping the environment, contributing to the
preservationofournaturalresources,andprotectinghumanhealth.