A-Coil
4.1.3 Codes & Regulations
This product is designed and manufactured to comply with national codes. It is
installer’s responsibilities to install the product in accordance with such codes and/or
any prevailing local codes/regulations. The manufacturer assumes no responsibilities
for equipment installed in violation of any codes or regulations.
These instructions are intended as a general guide and do not supersede local or
nat
ional codes in any way. Authorities who have jurisdiction should be consulted before
installation.
4.1.4 Replacement Parts
When reporting shortages or damages, or ordering repair parts, give the complete
product model and serial numbers as stamped on the product. Replacement parts for
this product are available through your contractor or local distributor.
4.2 Location
This coil is designed for indoor installation only. Do not install it
outdoors.
Not suitable for use with ammonia.
When installing the coil, take consideration to minimize the length of refrigerant
tubing as much as possible. Do not install the air handler in a location either above or
below the condenser that violates the instructions provided with the condenser. Service
clearance is to take precedence. Allow a minimum of 25” in front of the unit for service
clearance, as shown below.
To Next Page
Loading...
Need help?
General
