Gree GMV-PD160W/NAB-M

118
DC Inverter Multi
VRF Service Manual
Removal and Installation of Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant
inside the pipe system and that the power has been cut off.
Step Illustration Handling Instruction
1. Remove the power cord
Mark the power
cable colors and
corresponding
terminal codes
during removal.
Ɣ8VHVFUHZGULYHUWRORRVHQWKH
VFUHZV¿[LQJWKHSRZHUFDEOH
Ɣ3XOORXWWKHSRZHUFDEOH
Note: When removing the
power cable, please mark
the power cable color and
corresponding terminal, thus to
avoid error during reinstallation.
/RRVHQWKHQXWV¿[LQJWKH
compressor onto foundation.
Heat by welding
and pull the
exhaust /
suction pipe out.
Ɣ)LUVWO\KHDWWKHFRQQHFWLRQSLSH
of compressor by welding;
Ɣ7KHQSXOORXWWKHFRQQHFWLRQSLSH
Note: During welding, take care not
WROHWWKHÀDPHEXUQRWKHUHOHPHQWV
/RRVHQWKHQXWV¿[LQJWKH
compressor onto foundation.
Use spanner to remove the
EROWV¿[LQJWKHFRPSUHVVRU
Ɣ8VHVSDQQHUWRORRVHQWKH
QXWV¿[LQJWKHFRPSUHVVRU
onto the base seat
4. Remove the compressor
from chassis
Ɣ5HPRYHWKHFRPSUHVVRU
and replace it
Note: When replacing the
compressor, take care not to touch
the pipes and components beside.