Gree GMV-PD160W/NAB-M

122
DC Inverter Multi
VRF Service Manual
Removal and Installation of Oil Separator
Remark: Before removing the compressor, make sure that there is no refrigerant
inside the pipe system and that the power has been cut off.
Step Illustration Handling Instruction
1. Disconnect the oil
separator from the
connection pipe
Loosen
the four
points
Ɣ/RRVHQWKHWKUHHMRLQWVRQRLO
separator sub-assembly by welding;
then, pull out the connection pipe.
Note: During welding, take care not
WROHWWKHÀDPHEXUQRWKHUHOHPHQWV
2 Loosen the screws
¿[LQJWKHRLOVHSDUDWRU
Loosen the
screws
Ɣ8VHVFUHZGULYHUWRORRVHQWKH
VFUHZV¿[LQJWKHRLOVHSDUDWRU
3. Remove the oil
separator and replace it
Ɣ5HPRYHWKHRLOVHSDUDWRU
and replace it
4. Tighten the screws
¿[LQJWKHRLOVHSDUDWRU
Tighten the
screws
Ɣ8VHVFUHZGULYHUWRWLJKWHQWKH
VFUHZV¿[LQJWKHRLOVHSDUDWRU