Super Free Match
Service Manual
CONTROL
37
2) －
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly decreases set
temperature. In AUTO mode, set temperature is not adjustable.
3) ＋
Press this button to increase set temperature. Holding it down above 2 seconds rapidly increases set
temperature. In AUTO mode, set temperature is not adjustable.
4) MODE
Each time you press this button, a mode is selected COOL, DRY, FAN, and HEAT *, as the following:
*Note: Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not be displayed on
the LED of the indoor, and the unit will automatically select the suitable operation mode in accordance with the
room temperature to make indoor room comfortable.
5) FAN
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, , ,
, , then back to Auto.
Low speed Low-Medium speed Medium speed
Medium-High speed High speed
6) SWING
Press this button to set up &down swing angle, which circularly changes as below:
This remote controller is universal. If any command
,
or
is sent out, the unit will carry out the
command as
indicates the guide louver swings as:
7) I FEEL:
Press this button to turn on I FEEL function. The units automatically adjust temperature according to the
sensed temperature. Press this button again to cancel I FEEL function.
8)
Press this button to achieve the on and off of healthy and scavenging functions in operation status. Press this
button for the first time to start scavenging function; LCD displays“
”. Press the button for the second time to
start healthy and scavenging functions simultaneously; LCD displays“
” and “ ”. Press this button for the
third time to quit healthy and scavenging functions simultaneously. Press the button for the fourth time to start
To Next Page
Loading...
Need help?
General
