Gree Versati II Series - Clock Setting; General Set

32
Air to Water Heat Pump
Service Manual- Versati II Series
CONTROL
3�3�5 General Set
At the homepage, by pressing “GEN.” access to the GENERAL SET page. At this page, it is able to set “Temp�
unit”, “Language”, “On/off memory”, “Time & Date”, “Beeper” and “Back light”, as shown in the gure below.
No� Full Name Displayed Name Range Default Remarks
1 Temperature unit Temp. unit Celsius/Fahrenheit Celsius /
2 Language Language
中文
/English English /
3 On/off memory On/off memory On/Off On /
4 Time&Date Time&Date / / /
5 Beeper Beeper On/Off On /
6 Back light Back light Lighted/Energy save Energy save
“On”: it always lights
on.
“Eco”: it lights off
when there is no key
operation for 1 minute,
and will lights on
where there is any key
operation.
3�3�5�1 Clock Setting
1) At the homepage, by pressing “GEN�” access to the GENERAL SET page. Then, select “Time & Date” at
this page. After that, go to the “Time & Date” setting page by pressing the OK key.
2) Change the set value by pressing the Up/Down key. Then by pressing “Save”, a pop-up window will pop
up to remind if you are determined to save this setting. If so, press the OK key. If not, press the Cancel key to
not save this setting. The saving setting will update at the upper left corner of the control.