Gree Versati II Series - Auto Mode; Holiday Release; Quiet Mode; Quiet Timer

18
Air to Water Heat Pump
Service Manual- Versati II Series
CONTROL
[Notes]
①
“Hot water” will take precedence only when “Water tank” is available, other it will tell “Reserved”.
②
This setting will be memorized upon power failure.
3�3�2�7 Quiet Mode
Go to the FUNCTION page and locate “Quiet mode”, then, congure it through the Up/Down key, “On” or
“Off”.
[Notes]
①
It can be set to “On” or “Off” no matter if the unit is in operation or not.
②
Once it is activated, it should be deactivated manually or by Quiet Timer.
③
It will not memorized and defaulted to be off upon power failure.
④
It will be deactivated when the unit is turned off.
3�3�2�8 Quiet Timer
1) Go to the FUNCTION page and locate Quiet timer, then, access to the QUIET TIMER setting page.
2) At the QUIET TIMER setting page, select “Start time” or “End time” through the Left/Right keys and then
congure the desired time through the Up/Down keys.
3) When the mode setting is nished, then by pressing “Save”, a pop-up window will pop up to remind if
you are determined to save this setting. If so, press the “OK” key. If not, press the “Cancel” key to not save this
setting.
4) When the setting is saved, the control then will back to the FUNCTION page and the cursor will be where
the “Quiet timer” option is, then by the Up/Down key, it can be set to be “On” or “Off”.
Start time End time
08:30 17:30
8:30 2013-4-24
Wednesday
QUIET TIMER
Minute Save
[Notes]
①
Once it is activated, it should be deactivated manually.
②
It will not be memorized and be defaulted to be off upon power failure.
③
The saved “Start time” and “End time” will be memorized upon power failure.
④
It is congurable no matter if the unit is in operation or not.
3�3�2�9 Auto Mode
Go to the FUNCTION page and locate Auto mode, then, congure it through the Up/Down key, “On” or “Off”.
[Notes]
①
Once it is activated, it should be deactivated manually.
②
It will be defaulted to be off upon power failure.
③
At the “Parameter View” page, it is able to check the set point at the Auto mode.
④
When it is activated, it is allowed to set the room temperature but the set point does not take effective.
However, when it is deactivated, the unit will run according to this set point.
⑤
It can be set to “On” or “Off” no matter if the unit is in operation or not, but be activated only when the
unit is in operation.
⑥
This mode works only for the air conditioning function.
3�3�2�10 Holiday Release
Go to the FUNCTION page and locate “Holiday release”, then, congure it through the Up/Down key, “On”
or “Off”.
[Notes]
①
When it is activated, at the WEEKLY TIMER page, it is able to set some week day to “Holiday
release”. In this case, the “Weekly timer” in this day is ineffective unless it is set to “Effective” manually.
②
This setting will be memorized upon power failure.