Greenlee Textron / Subsidiary of Textron Inc.
4
4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070
555BAT™ Battery-Powered Bender
SAVE THESE INSTRUCTIONS
Additional copies of this manual are available upon request at no charge.
IMPORTANT SAFETY INSTRUCTIONS
Batteries can produce explosive
hydrogen gas.
• Use this bender in well-ventilated
areas.
• Do not allow metal or conductive
objects to contact the battery
terminals.
• Use insulated tools when connect-
ing or disconnecting battery
cables.
• Do not use this bender near an
open flame.
Failure to observe these warnings
will result in severe injury or death.
Do not use automotive batteries. Use only
PowerSonic Model PS-12600 or equivalent deep
cycle-type batteries. Other batteries can overheat,
explode or vent explosive hydrogen gas.
Keep terminal covers in place and the battery
compartment closed during operation and storage.
The battery compartment must be closed to protect
the batteries and battery cables from damage.
Failure to observe this warning can result in severe
injury or death.
Do not attempt to charge a very cold or frozen
battery. Damage to the battery could result,
causing acid to spray out.
Failure to observe this warning can result in
severe injury or death.
Batteries contain acid. Wear rubber
gloves and face shield. Use insu-
lated tools when inspecting or
working with the batteries.
Failure to observe this warning can
result in severe injury.
Electric shock hazard:
• Do not modify the charger power
cord or plug.
• Inspect the charger power cord
before connecting to a power
source.
• Connect the charger power cord
to a 120V, 15-amp grounded
receptacle only.
Failure to observe these warnings
can result in severe injury or death.
To Next Page
Loading...
