17
W450311 Rev C 2/13
4.7 Replacing the Display Console
REMOVAL
1. Disconnect the electrical cable from the rear of the Operator’s Display Console.
2. Remove the knob on each side of the console and retain for future use.
3. Remove the defective display console from the bracket in the cab.
INSTALLATION
1. Put the Operator’s Display Console on the bracket located in the cab, by positioning it between
the bracket legs.
2. Insert and tighten the knob on each side of the console.
3. Connect the electrical cable to the rear of the console.
To Next Page
Loading...
Need help?
General