GREER Company Insight Calibration And Troubleshooting Manual

4
W450311 Rev C 2/13
2.1 System Self-Test
When the power is turned on, the system performs a self-test. This verifies the computer, display
console, cable, and sensors are working properly. During the self-test, the display will show the
expected crane model, load chart number and units of measurement.
When the display shows the following message, press the “PRESS TO CONTINUE” button.
If the above does not occur, refer to Display Console Problems.

GREER Company Insight Specifications

General

Brand	GREER Company
Model	Insight
Category	Control Panel
Language	English