Cycle Analyst V3.1 User Manual
Rev 1.0
8 Software Setup Utility
The Cycle Analyst Setup Utility software is available for Windows, MacOS, and
Linux, and it lets you edit all the CA3 parameters by computer rather than
through the two button interface. The software also allows you to update and
reflash the firmware on the Cycle Analyst, and load various special purpose
firmwares like the Solar CA code or GPS code.
The software suite and instructions for using it are both on the CA3 info page
https://www.ebikes.ca/product-info/cycle-analyst-3.html
Even if the software utility is not used for flashing new settings on your device, it
is still useful as a reference for learning in greater detail the function of each and
every setting on your CA. There is a detailed tooltip that will show up when you
hover the mouse over any setting of interest, and these can be seen all in one file
by going Help->Help
There are certain items that can't be changed from the device and do require the
software tool. These are in the OEM category, and include the abillity to hide
items inside the setup menu itself and also set a total upper bounds for the
maximum power, speed, and current limits that the user can configure.
33
To Next Page
Loading...
Need help?
General