Grizzly G0699 - Page 7

Model G0699 (Mfd. Since 5/15)
-5-
The information contained herein is deemed accurate as of 9/18/2018 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3
Model G0699
Scoring Blade
Horsepower................................................................................................................................................ 1 HP
Phase.................................................................................................................................................... 3-Phase
Amps...................................................................................................................................................... 3A/1.5A
Speed................................................................................................................................................ 3450 RPM
Type........................................................................................................................................... TEFC Induction
Power Transfer .................................................................................................................................. Belt Drive
Bearings..................................................................................................... Shielded & Permanently Lubricated
Centrifugal Switch/Contacts Type................................................................................................................ N/A
Main Specifications:
Operation Information
Main Blade Size......................................................................................................................................... 12 in.
Main Blade Arbor Size................................................................................................................................. 1 in.
Scoring Blade Size................................................................................................................ 4-3/4 in. (120 mm)
Scoring Blade Arbor Size........................................................................................................................ 20 mm
Main Blade Tilt.................................................................................................................................. 0 – 45 deg.
Main Blade Speed............................................................................................................................. 4000 RPM
Scoring Blade Tilt............................................................................................................................. 0 – 45 deg.
Scoring Blade Speed......................................................................................................................... 8000 RPM
Cutting Capacities
Max Depth of Cut At 90 Deg................................................................................................................ 3-5/16 in.
Max Depth of Cut At 45 Deg.................................................................................................................. 2-3/8 in.
Rip Fence Max Cut Width.................................................................................................................... 49-3/4 in.
Sliding Table w/Crosscut Fence Max Cut Width...................................................................................... 126 in.
Sliding Table w/Crosscut Fence Max Cut Length.................................................................................... 126 in.
Miter Fence Max Cut Width at 45 Deg..................................................................................................... 126 in.
Table Information
Floor To Table Height................................................................................................................................ 36 in.
Table Size Length................................................................................................................................ 21-1/2 in.
Table Size Width................................................................................................................................. 35-1/4 in.
Table Size Thickness................................................................................................................................... 3 in.
Table Size With Ext Wings Length............................................................................................................ 59 in.
Table Size With Ext Wings Width.............................................................................................................. 68 in.
Table Size With Ext Wings Thickness......................................................................................................... 3 in.
Sliding Table Length................................................................................................................................ 126 in.
Sliding Table Width.................................................................................................................................... 14 in.
Fence Information
Crosscut Fence Type....................................................................... Single Lever Locking, Extruded Aluminum
Crosscut Fence Size Length...................................................................................................................... 73 in.
Crosscut Fence Size Width................................................................................................................... 2-3/8 in.
Construction Materials
Table....................................................................................................................... Precision-Ground Cast Iron
Sliding Table....................................................................................................................................... Aluminum
Cabinet....................................................................................................................................................... Steel
Rip Fence Rails......................................................................................................................... Hardened Steel
Guard....................................................................................................................................................... Plastic
Spindle Bearing Type............................................................... Lubricated & Permanently Sealed Ball Bearing
Cabinet Paint Type/Finish.......................................................................................................... Powder Coated
Other Related Information
No of Dust Ports............................................................................................................................................... 2
Dust Port Size.......................................................................................................................................... 4, 5 in.