-2-
Model G0925 (Mfd. Since 2/20)
5. Remove (2) pre-installed tap screws, Phillips
head screw, and hex nut (see Figure 2) from
chuck guard seat.
6.
Attach chuck guard to chuck guard seat
using fasteners removed in Step 5 (see
Figure 4).
Figure 4. Attaching chuck guard to chuck guard
seat.
Figure 2. Location of chuck guard seat screws.
Tap Screws
Hex Nut
Phillips Head
Screw
Revised Inventory List
Box 1 (Figure 1) Qty
K. Pointer ........................................................ 1
L
. Threaded Depth Rod Assembly ................. 1
M
. Chuck Guard Assembly ............................. 1
N
. Chuck Guard Seat Assembly ..................... 1
Figure 1. Box 1 additions.
K
L
M
N
Perform Steps 1–4 of Assembly on Page 15 of
owner's manual. Then follow the steps below to
complete the assembly process.
Revised Assembly Steps
Figure 3. Aligning chuck guard to chuck guard
seat.
To Next Page
Loading...
Need help?
General
