Groen Eclipse BPM-40G User Manual

20 OM/SM-BPM-G
WARNING
DO NOT SPRAY WATER DIRECTLY ON
BURNERS AND GAS COMBUSTION
CHAMBERS.
7. The exterior surface of the unit may be polished
with a recognized stainless steel cleaner.
NOTICE
NEVER LEAVE A CHLORINE SANITIZER IN
CONTACT WITH STAINLESS STEEL SURFACES
LONGER THAN 30 MINUTES. LONGER
CONTACT CAN CAUSE CORROSION.
8. If the equipment needs to be sanitized, use a
sanitizing solution equivalent to one that supplies 100
parts per million available chlorine. Obtain advice on
the best sanitizing agent from your supplier of
sanitizing products. Following the supplier's
instructions, apply the sanitizing agent after the unit
has been cleaned and drained. Rinse o the sanitizer
thoroughly.
9. If there is diculty removing mineral deposits or a
lm left by har
d water or food residues, clean the pan
thoroughly and then use a deliming agent, such as
Groen De-limer/De-Scaler (P/N 140513), in
accordance with the manufacturer's directions. Rinse
and drain the unit before further use.
10. If especially dicult cleaning problems persist,
contact your cleaning product representative for
assistance.
7. Maintenance
Your Braising Pan is designed to require minimum
maintenance, but certain parts may need replacement
after prolonged use. After installation, no user
adjustment should be necessary. If a service need
arises, only authorized personnel should perform the
work.
WARNING
ELECTRIC POWER ALWAYS SHOULD BE
S
HUT OFF BEFORE WORK IS DONE ON
INTERNAL COMPONENTS.
Service personnel should check the unit at least once
a year. This periodic maintenance should include
inspecting electrical wires and connections,
cleaningtheinside of the control console, and possible
adjustment of the pilot light. (Units with
standing pilot ignition only) At least twice a year,
grease the two trunnion bearings and worm gear (see
paragraph 3.1.2.b Gears).
Groen recommends the use of number two grade LGI
lithium grease. Add grease through the zerk ttings on
the gear hosing until grease ows out of the bearings
around trunnion shaft. Also, add grease in the gear to
cover arc that is in contact with the worm gear. Clean
up excess grease.
WA
RNING
DISCONNECT ELECTRICAL POWER FROM
THE UNIT BEFORE ATTEMPTING TO GREASE
THE TRUNNION BEARINGS.
AService Logis providedwiththe warrantyinformation
at the back of this manual. Each time service is
performed onyourGroenequipment, enterthedateon
which the work was done, whatwas done, and who did
it. Keep the manual with the equipment for quick and
easy reference.
20
6. Safety Precautions
A stop-cock will be fitted in the gas pipe supplying the appliance. The user must be familiar with its location and
operation, and able to turn it off in an emergency.
If there is a smell of gas, immediately turn off the gas, ventilate the area, and call the gas supplier.
NEVER USE NAKED FLAME TO SEARCH FOR GAS LEAKS.

Groen Eclipse BPM-40G Specifications

General

Brand	Groen
Model	Eclipse BPM-40G
Category	Commercial Food Equipment
Language	English