EasyManua.ls Logo

Grote 613-VS2-LES - 7. Breaking Blades; 8. Excessive Product Scrap; 9. Product Curling or Twisting; 0. P R O D U C T S L I N G I N G

Default Icon
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Model 613-VS2-LES, Log End Slicer Troubleshooting
R-1176866 613-VS2-LES_CJL20160114.doc:1/15/2016 4:21 PM Grote Company 55
7. BREAKING BLADES
Not Enough Water - Check water pump for proper operation and output.
Blade Not Tracking Correctly - Check blade and guide for product residue. Check water applicator
ports for product residue; clean with pressurized air. Re-track according to manual.
Blade Tension Spring Worn, Broken, or Rusty - Replace spring.
Idle Side Bearing Block Not Moving Correctly - Block must move freely with one hand. Clean if
necessary.
Blade Guide Dirty or Adjusted Improperly Clean with Blade Guide tool. Check manual for
proper adjustment.
Improper Product Holder Clearance - No less than 1/32” no more than 1/16” from trailing edge of
product holder to the blade.
8. EXCESSIVE PRODUCT SCRAP
Incorrect Product Temperature - Verify product temperature is within the proper range for slicing.
Improper Loading of Product - Stop machine. Check product and tube sizes for proper fit.
Improper Product Holder Clearance - No less than 1/32” no more than 1/16” from trailing edge of
product holder to the blade.
Blade Dull or Inside Out - Replace or re-install correctly.
Blade Guide Dirty or Adjusted Improperly Clean with Blade Guide tool. Check manual for
proper adjustment.
Thickness Tray not Level - Place straight edge from blade guide to thickness tray and level side
to side, front to back.
9. PRODUCT CURLING OR TWISTING
Incorrect Product Temperature - The colder the product the more severe the curl; the warmer,
the more severe the twisting. Verify product temperature is within the proper range for slicing.
Improper or Worn Blade Guide – Check for wear with Blade Guide tools. Use the correct style
blade guide for your slicing application. Contact Grote Service.
10. PRODUCT SLINGING
Not Enough Water - Check water pump for proper operation and output.
Not Enough Product Weight in Product Holders - Product holders must be at least 2/3 full.
Improper Loading of Product - Stop machine. Check product and tube sizes for proper fit.
Incorrect Product Temperature - Verify product temperature is within the proper range for slicing.
Blade not Tracking Correctly - Check blade and guide for product residue. Check water ports.
Track the blade according to manual.
Incorrect X-Gap - Reset X-gap according to manual.
Improper Product Holder Clearance - No less than 1/32” no more than 1/16” from trailing edge of
product holder to the blade.

Table of Contents

Related product manuals