EasyManua.ls Logo

Grote 613-VS2-LES - 6. P R O D U C T Tailing; 7. P R O D U C T T H I C K N E S S V a R I E S F R O M S I D E to Side; 8. P R O D U C T T H I C K N E S S V a R I E S F R O M F R O N T to B Ac; 9. P R O D U C T M I S S E S Cluster

Default Icon
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Model 613-VS2-LES, Log End Slicer Troubleshooting
R-1176866 613-VS2-LES_CJL20160114.doc:1/15/2016 4:21 PM Grote Company 57
16. PRODUCT TAILING
Incorrect Product Temperature - Verify product temperature is within the proper range for slicing.
Blade not Tracking Correctly - Check blade and guide for product residue. Check water ports.
Track the blade according to manual.
Dull Blade - Replace blade.
Thickness Tray not Level from Front to Back - Place straight edge on blade guide and reset
thickness tray level from front to back at ground zero.
Incorrect Slice Gap - Reset slice gap according to chart in manual.
Improper Product Holder Clearance - No less than 1/32” no more than 1/16” from trailing edge of
product holder to the blade.
17. PRODUCT THICKNESS VARIES FROM SIDE TO SIDE
Improper Loading of Product - Stop machine. Check product and tube sizes for proper fit.
Blade not Tracking Correctly - Check blade and guide for product residue. Check water ports.
Track the blade according to manual.
Thickness Tray not Level from Side to Side - Place straight edge on blade guide and reset
thickness tray level from side to side.
18. PRODUCT THICKNESS VARIES FROM FRONT TO BACK
Improper Loading of Product - Stop machine. Check product and tube sizes for proper fit.
Blade not Tracking Correctly - Check blade and guide for product residue. Check water ports.
Track the blade according to manual.
Blade Guide not Adjusted - Check manual for proper settings.
Incorrect X-Gap - Reset X-gap according to manual.
Thickness Tray not Level from Front to Back - Place straight edge on blade guide and reset
thickness tray level from front to back at zero thickness.
19.PRODUCT MISSES CLUSTER
Product holder not centered
Product guides on aligned properly at the feed conveyor
Feed time too long will double load product – this may take several load cycles to show
Injection time too short

Table of Contents

Related product manuals