4.14 Error 56
.....................................................................................................................................................19
4.15 Error 58
.....................................................................................................................................................20
4.16 Error 60
.....................................................................................................................................................20
4.17 Error 80
.....................................................................................................................................................20
4.18 Error 81
.....................................................................................................................................................21
4.19 Error 20
.....................................................................................................................................................21
5 Contact
................................................................................................................................................................... 22
1 General
This document is applicable for Growatt SPF3000TL HVM and SPF5000TL HVM models
off grid inverters.
An error message will be displayed on the LCD screen while fault occurs. The faults can
be categorized as erro and warning . All faults with erro code will stop inverter power
generation. Accompanied with red LED indicator ON immediately, and showing consistent
until the fault had been cleared.
When a Warning message is shown on inverter LCD display, the inverter will continue
working but will be accompanied by flashing red LED indicator.
You may be advised to contact Growatt in some circumstance, please provide the
following information.
Information concerning the inverter:
Serial number
Model number
Error or warning message on LCD
Brief description of the problem
Grid voltage measured
DC input voltage
Battery specification
Load capacity and list
Can you reproduce the failure? If yes, how to?