Grundfos CUE Series Product Guide

Introduction
Grundfos CUE
5
Designed for Grundfos pumps
The CUE can be used in both new and existing instal-
lations, but the pump and motor should be suitable for
use
with frequency converters.
The table below shows which Grundfos pump types the
C
UE is designed for.
Further technical documentation
• Installation and operating instructions contain all in-
formation for putting the CUE into operation.
• Installation and operating instructions of the MCB
1
14 sensor input module contain all information for
installation of the MCB 114.
Technical documentation is available on www.grund-
fos.com > International website > WebCAPS.
If you have any questions, please contact the nearest
Grundf
os company or service workshop.
Pump type
AFG
AMD
AMG
BM, BMB, BMP
BME, BMET, BMEX
CH, CHI, CHN, CHV
CHIU
Contra
CPH, CPV
CR, CRI, CRN, CRT
CRK
CV
DP, EF
durietta
Euro HYGIA
F&B HYGIA
HS
LC, LF
MAXA, MAXANA
MTA, MTH, MTR
MTB
NB, NK
NBG, NKG
S
SE, SEN, SEV
SP,SP-G, SP-NE
SPK
SRP
TP
VL

Grundfos CUE Series Specifications

General

Category	DC Drives
Output Voltage	24 V DC
Control Signal	0-10 V, 4-20 mA
Communication	Modbus RTU
Protection Features	Overvoltage, overcurrent, overtemperature, short circuit
Humidity	5% to 95% (non-condensing)
Enclosure class	IP20
Enclosure Rating	IP20