Grundfos MAGNA3 40-80 F (N) - Product Operation Guidelines; Home Menu Navigation

English (GB)
23
8.1 Operating the product
Fig. 33 Control panel
8.1.1 Menu structure
The pump incorporates a startup guide which is started at the first
startup. After the startup guide, the four main menus appear in
the display. See section 7. Control functions.
"
+RPH
"
This menu shows up to four user-defined parameters with
shortcuts or a graphical illustration of a performance curve. See
section 8.2 "
+RPH " menu.
6WDWXV
This menu shows the status of the pump and system as well as
warnings and alarms. See section 8.4
6WDWXV menu.
"
6HWWLQJV
"
This menu gives access to all setting parameters. You can make
a detailed setting of the pump in this menu. See section
8.6 "
6HWWLQJV " menu.
"
$VVLVW
"
This menu enables assisted pump setup, provides a short
description of the control modes and offers fault advice. See
section 8.8 "
$VVLVW " menu.
8.2 "
+RPH
" menu
Navigation
"+RPH"
Press to go to the "+RPH" menu.
"
+RPH
" menu, factory setting
• Shortcut to control mode settings
• Shortcut to setpoint settings
• "Estimated flow rate"
•"+HDG".
Navigate in the display with or and change between the two
shortcuts with or .
You can define the +RPH display. See section "
'HILQH+RPH
GLVSOD\
".
8.2.1 "Home" display icons
CAUTION
Hot surface
Minor or moderate personal injury
- At high liquid temperatures, the pump housing may
be so hot that only the control panel should be
touched to avoid burns.
TM05 3820 1612
Button Function
Goes to the "+RPH" menu.
Returns to the previous display.
Navigates between main menus, displays and
digits.
When the menu is changed, the display always
shows the top display of the new menu.
Navigates between submenus.
Saves changed values, resets alarms and expands
the value field.
You cannot make settings in this menu.
Undef-010
Symbol Description
Automatic night setback function is enabled.
Settings are locked. You cannot adjust settings
from the display.
The pump is in remote mode, for example from
fieldbus.
The multipump system is active.
Master pump in a multipump system.
Slave pump in a multipump system.
Forced local mode is active.
You cannot set the pump to remote mode, for
example from fieldbus.