Grundfos MAGNA3 40-80 F (N) - Pump Status Information; Pump Settings Menu; Setpoint Configuration

English (GB)
26
8.4
6WDWXV
menu
Navigation
"+RPH" > 6WDWXV
Press and go to the 6WDWXV menu with .
6WDWXV
menu
This menu offers the following status information:
•"2SHUDWLQJVWDWXV"
•"3XPSSHUIRUPDQFH"
•"3RZHUDQGHQHUJ\FRQVXPSWLRQ"
•":DUQLQJDQGDODUP"
•"+HDWHQHUJ\PRQLWRU"
•"2SHUDWLQJORJ"
•")LWWHGPRGXOHV"
•"'DWHDQGWLPH"
•"3XPSLGHQWLILFDWLRQ"
•"0XOWLSXPSV\VWHP".
Navigate between the submenus with or .
8.5 "
2SHUDWLQJVWDWXV
"
Navigation
"+RPH" > 6WDWXV > "2SHUDWLQJVWDWXV"
"2SHUDWLQJVWDWXV"
•"2SHUDWLQJPRGHIURP"
•"&RQWUROPRGH".
This example shows that the pump runs in normal operation in a
multipump system.
The status in the submenus gives information about the pump
settings and other operational parameters.
Navigate between the submenus with or .
8.6 "
6HWWLQJV
" menu
Navigation
"+RPH" > "6HWWLQJV"
Press and go to the "6HWWLQJV" menu with .
"
6HWWLQJV
" menu
This menu offers the following setting options:
•"6HWSRLQW"
•"2SHUDWLQJPRGH"
•"&RQWUROPRGH"
•"&RQWUROOHUVHWWLQJV", not model A
•")/2:/,0,7"
•"$XWRPDWLF1LJKW6HWEDFN"
•"$QDORJ,QSXW"
•"5HOD\RXWSXWV"
•"6HWSRLQWLQIOXHQFH"
•"%XVFRPPXQLFDWLRQ"
•"*HQHUDOVHWWLQJV".
Navigate between the submenus with or .
8.6.1 "
6HWSRLQW
"
Navigation
"+RPH" > "6HWWLQJV" > "6HWSRLQW"
"
6HWSRLQW
"
Set the setpoint so that it matches the system.
Setting:
1. Press [OK].
2. Select digit with and and adjust with or .
3. Press [OK] to save.
A too high setting may result in noise in the system whereas a too
low setting may result in insufficient heating or cooling in the
system.
2.1.0.0.0.0 6WDWXV
2.1.1.0.0.0 Operating mode
3.1.0.0.0.0 6HWWLQJV3.1.1.0.0.0 6HWSRLQW
Control mode Measuring unit
Proportional pressure m, ft
Constant pressure m, ft
Constant temperature °C, °F, K
Constant curve %