Grundfos MAGNA3 40-80 F (N) - Factory Settings Reset

English (GB)
38
"
'LVSOD\EULJKWQHVV
"
Navigation
"+RPH" > "6HWWLQJV" > "*HQHUDOVHWWLQJV" > "'LVSOD\EULJKWQHVV"
"
%ULJKWQHVV
"
1. Press [OK].
2. Set brightness with and .
3. Press [OK] to save.
"
5HWXUQWRIDFWRU\VHWWLQJV
"
Navigation
"+RPH" > "6HWWLQJV" > "*HQHUDOVHWWLQJV" > "5HWXUQWRIDFWRU\
VHWWLQJV"
"
5HWXUQWRIDFWRU\VHWWLQJV
"
You can recall the factory settings and overwrite the current
settings. All user settings in the "6HWWLQJV" and "$VVLVW" menus are
set back to the factory settings. This also includes language,
units, setup of analog input, multipump function, etc.
To overwrite the current settings with the factory settings, select
"<HV" with or and press [OK].
"
5XQVWDUWXSJXLGH
"
Navigation
"+RPH" > "6HWWLQJV" > "*HQHUDOVHWWLQJV" > "5XQVWDUWXSJXLGH"
"
5XQVWDUWXSJXLGH
"
The startup guide automatically starts when you start the pump
for the first time.
You can always run the startup guide later via this menu. The
startup guide guides the user through the general settings of the
pump, such as language, date and time.
To run the startup guide, select "<HV" with or and press
[OK].
8.8 "
$VVLVW
" menu
Navigation
"+RPH" > "$VVLVW"
Press and go to the "$VVLVW" menu with .
"
$VVLVW
" menu
This menu offers the following:
•"$VVLVWHGSXPSVHWXS"
•"6HWWLQJRIGDWHDQGWLPH"
•"0XOWLSXPSVHWXS"
•"6HWXSDQDORJLQSXW"
•"'HVFULSWLRQRIFRQWUROPRGH"
•"$VVLVWHGIDXOWDGYLFH".
The "$VVLVW" menu guides the user through the setting of the
pump. In each submenu, there is a guide that guides the user
through the setting of the pump.
8.8.1 "
$VVLVWHGSXPSVHWXS
"
This menu guides you through a complete pump setup, starting
with a presentation of the control modes and ending with the
setpoint setting.
8.8.2 "
6HWWLQJRIGDWHDQGWLPH
"
See section "
6HWGDWHDQGWLPH ".
3.1.19.7.1.0 %ULJKWQHVV3.1.19.10.1.0 5HWXUQWRIDFWRU\VHWWLQJV3.1.19.11.0.0 5XQVWDUWXSJXLGH
$VVLVW