Grundfos MAGNA3 40-80 F (N) - Analog Input Function Setup; Relay Output Function Setup

English (GB)
32
8.6.7 "
$QDORJ,QSXW
"
In this menu, you can set an analog input such as a temperature
sensor to activate the heat-energy-monitor function. See fig. 57.
Navigation
"+RPH" > "6HWWLQJV" > "$QDORJ,QSXW"
"
$QDORJ,QSXW
"
•")XQFWLRQRIDQDORJLQSXW"
•"8QLW"
•"6HQVRUUDQJHPLQYDOXH"
•"6HQVRUUDQJHPD[YDOXH"
•"(OHFWULFDOVLJQDO".
"
)XQFWLRQRIDQDORJLQSXW
"
Choose the function of input, for example heat energy monitor as
in the example below.
Navigation
"+RPH" > "6HWWLQJV" > "$QDORJ,QSXW" > ")XQFWLRQRIDQDORJLQSXW"
•"1RWDFWLYH"
•"'LIIHUHQWLDOSUHVVXUHFRQWURO"
•"&RQVWDQWWHPSHUDWXUHFRQWURO"
•"'LIIHUHQWLDOSUHVVXUHFRQWURO"
•"+HDWHQHUJ\PRQLWRU"
•"([WHUQDOVHWSRLQWLQIOXHQFH"
Setting:
1. Select function mode with or .
2. Press [OK] to enable the function mode.
When you have selected the function of the input, specify the
sensor parameters by filling in the right values in unit, sensor
range, etc.
You can also set the analog input via the "Assist" menu where a
wizard guides you through each step of the configuration. See
8.8.5 "
6HWXSDQDORJLQSXW ".
8.6.8 "
5HOD\RXWSXWV
"
Navigation
"+RPH" > "6HWWLQJV" > "5HOD\RXWSXWV"
"
5HOD\RXWSXWV
"
•"5HOD\RXWSXW"
•"5HOD\RXWSXW".
You can set the relay outputs to the following:
•"1RWDFWLYH"
•"5HDG\"
•"$ODUP"
•"2SHUDWLRQ".
The pump incorporates two signal relays for a potential-free
alarm signal, ready signal and operating signal. For further
information, see section 7.4.1 Relay outputs.
Set the function of the signal relays, alarm signal (factory setting),
ready signal and operating signal on the pump control panel.
The output is electrically separated from the rest of the controller.
The signal relay is operated as follows:
•"1RWDFWLYH"
The signal relay is deactivated.
•"5HDG\"
The signal relay is active when the pump is running or has
been set to stop, but is ready to run.
•"$ODUP"
The signal relay is activated together with the red indicator
light on the pump.
•"2SHUDWLRQ"
The signal relay is activated together with the green indicator
light on the pump.
3.1.7.0.0.0 Analog input3.1.7.1.0.0 Function of input
3.1.12.0.0.0 5HOD\RXWSXWV