Clock Settings
When the Corti test instrument is first used, the correct date and time
may need to be set on its internal clock. The clock should be set prior
to testing, as changing it after tests are saved will not change the date
on the printout.
Seasonal time changes such as Daylight Saving Time will also require
resetting the clock. If the instrument is being powered on for the first
time or if the instrument’s battery is completely discharged and the
battery is not charged within approximately one hour, Error!
Reference source not found. may appear. If this message appears,
reset the time and date.
Accessing the Clock Menu
To change the time and date press CHANGE at the main menu
(Display 1) and then press SETUP at the protocol selection display
(Display 2). The current date and time presently set in the unit will be
shown (Display 15). If the time and date are correct, press the UP key
to escape back to the main menu.
Changing the Date/Time
If either the date or time is incorrect, press the CHANGE key to
access the menu to change the month (Display 16). Press the LEFT
or RIGHT keys to scroll forward or backward through the months.
The abbreviated name for each month will be displayed (Display 17).
When the desired month appears on the display, press the NEXT
key to enter the day selection screen. Pressing the LEFT or
RIGHT keys will scroll through the days of the month. After the
correct day is selected, press the NEXT key to enter the day
selection display. Again use the LEFT or RIGHT arrow keys to
set the correct day. Repeat this process for the year, hour, and minute
using the LEFT or RIGHT arrow keys to make the selection and
the NEXT key to advance to the next display.
When the correct minute is selected, pressing the DONE arrow key
(Display 17) will return to the Main Menu.
The time and date changes are automatically saved.
To Next Page
Loading...
Need help?
General
