5. Assembly
PNEG-750-G2 16" Series II Sweep 131' and 135' Diameter 29
E. Bolt the bearing support brackets to the legs of the tractor drive stand using 1/2" x 1-3/4" bolts,
1/2" lock washers, 1/2" bevel washers and 1/2" hex nuts. (See Figure 5K.)
Figure 5K
F. Attach pillow block bearings to the bearing support brackets using 5/8" x 2-1/2" bolts, 5/8" lock and
flat washers and 5/8" hex nuts. (See Figure 5L.)
Figure 5L
G. Tighten set screws on pillow block bearings.
H. Tighten all hardware.
To Next Page
Loading...