5. Assembly
50 PNEG-750-G2 16" Series II Sweep 131' and 135' Diameter
3. Feed the power cord through the pivot tube. (See Figure 5AJ.)
4. Align the hole in the back shield with the pivot tube and push the sweep onto the pivot tube.
(See Figure 5AJ.)
5. Connect the pivot plate to the back shield using two (2) 1/2"-13 x 1-3/4" hex bolts, flat washers,
lock washers and hex nuts. (See Figure 5AJ.)
6. Fasten the pivot rod to the back shield and pivot plate using two (2) 1/2"-13 x 2" hex bolts, lock
washers and hex nuts. (See Figure 5AJ.)
7. Screw the 45° grease fitting into the pivot assembly pipe. (See Figure 5AJ.)
Figure 5AJ
To Next Page
Loading...